Generator
AUTOMATIC MAINS FAILURE ? ENHANCED AUTO/AMF SURF V1.3a
� Microcontroller based design.
� Automatic mains failure or Auto Start controller.
� 3.5� TFT screen.
� Simultaneous display of AC voltage, currents, frequency, hour counter, oil pressure, engine temperature, oil temperature, and battery voltage.
� Display of power in KW and energy in KWh of both engine and Utility.
� Display of fuel consumption rate (L/h), total fuel consumption, tank percentage, and RPM.
� Display of power factor of each line.
� Display of Software version, the internet connection status, the date and time, the continuous hour counter, and the utility hour counter.
� 4/8GB Micro SD card for event and data logging.
� CAN bus J1939 enabled.
� CAN bus with BAMVI_CAN that can read DC voltage up to 275Vdc and DC current up to �300Amps. More than one BAMVI-CAN can be connected to the bus (optional).
� Ethernet interface.
� SNMP Server protocol (Get/Set using Versions v1/v2c, send traps with compliance to RFC1215).
� SNTP Client (Automatically synchronize time with a modifiable SNTP server).
� HTTP Server protocol (Retrieve logs/Download Firmware via Ethernet).
� USB interface.
� Serial RS232S interface (optional).
� Serial RS485.Modbus protocol.
� Internet communication: no software installation required.
� Galvanic isolation for utility and Genset AC inputs.
� Parameters can be edited and updated from any remote interface at any time even when the engine is running.
� Menu is accessible from the front panel as well as USB, Ethernet.
� Supports communication and SMS via GSM modem.
� Supports 4-pole systems (Utility and Genset AC inputs are isolated).
� Accepts Genset frequencies of up to 500Hz.
� Supports three current inputs for 50Hz current transformers or up to 500Hz using current transducers (optional and sold separately).
� Operation by push buttons.
� Automatic mains failure or Auto Start controller.
� 3.5� TFT screen.
� Simultaneous display of AC voltage, currents, frequency, hour counter, oil pressure, engine temperature, oil temperature, and battery voltage.
� Display of power in KW and energy in KWh of both engine and Utility.
� Display of fuel consumption rate (L/h), total fuel consumption, tank percentage, and RPM.
� Display of power factor of each line.
� Display of Software version, the internet connection status, the date and time, the continuous hour counter, and the utility hour counter.
� 4/8GB Micro SD card for event and data logging.
� CAN bus J1939 enabled.
� CAN bus with BAMVI_CAN that can read DC voltage up to 275Vdc and DC current up to �300Amps. More than one BAMVI-CAN can be connected to the bus (optional).
� Ethernet interface.
� SNMP Server protocol (Get/Set using Versions v1/v2c, send traps with compliance to RFC1215).
� SNTP Client (Automatically synchronize time with a modifiable SNTP server).
� HTTP Server protocol (Retrieve logs/Download Firmware via Ethernet).
� USB interface.
� Serial RS232S interface (optional).
� Serial RS485.Modbus protocol.
� Internet communication: no software installation required.
� Galvanic isolation for utility and Genset AC inputs.
� Parameters can be edited and updated from any remote interface at any time even when the engine is running.
� Menu is accessible from the front panel as well as USB, Ethernet.
� Supports communication and SMS via GSM modem.
� Supports 4-pole systems (Utility and Genset AC inputs are isolated).
� Accepts Genset frequencies of up to 500Hz.
� Supports three current inputs for 50Hz current transformers or up to 500Hz using current transducers (optional and sold separately).
� Operation by push buttons.
Downloads