AUTOMATIC MAINS FAILURE − ENHANCED AUTO/AMF − SURF V1.3a
- Microcontroller based design.
- Automatic mains failure or Auto Start controller.
- 3.5" TFT screen.
- Simultaneous display of AC voltage, currents, frequency, hour counter, oil pressure, engine temperature, oil temperature and battery voltage.
- Display of power in KW and energy in KWh of both engine and Utility.
- Display of fuel consumption rate (L/h), total fuel consumption, tank percentage, and RPM.
- Display of power factor of each line.
Display of Software version, the internet connection status, the date and time, the continuous hour counter, and the utility hour counter.
- 4/8GB Micro SD card for event and data logging.
- CAN bus J1939 enabled.
CAN bus with BAMVI_CAN that can read DC voltage up to 275Vdc and DC current up to ±300Amps. More than one BAMVI-CAN can be connected to the bus (optional)
- Ethernet interface.
- SNMP Server protocol (Get/Set using Versions v1/v2c, send traps with compliance to RFC1215).
- SNTP Client (Automatically synchronize time with a modifiable SNTP server).
- HTTP Server protocol (Retrieve logs/Download Firmware via Ethernet) - under development.
- USB interface.
- Serial RS232S interface (optional).
- Serial RS485.Modbus protocol.
- Internet communication: no software installation required - under development.
- Galvanic isolation for utility and Genset AC inputs.
- Parameters can be edited and updated from any remote interface at any time even when the engine is running.
- The menu is accessible from the front panel as well as USB, Ethernet.
- Supports communication and SMS via GSM modem.
- Supports 4-pole systems (Utility and Genset AC inputs are isolated).
- Accepts Genset frequencies of up to 500Hz.
Supports three current inputs for 50Hz current transformers or up to 500Hz using current transducers (optional and sold
separately).
- Operation by push buttons.